Showing 541–570 of

This small kit will allow you to assemble a small Tesla coil. The kit itself is quite simple and can be soldered in 10-15 minutes. All components are signed directly on the board. There is only one caveat when installing a coil.. The coil is attached to the board with glue with the longer end of the wire facing up. A properly assembled device starts working immediately. The supply voltage of the device can range from 12 to 30 volts at a current up to 1,5 – 2 ampere.

The set comes with a small piece of thick wire insulated. It is needed in order to make the primary winding of the transformer. When winding the primary, it is very important that its direction coincides with the direction of winding of the coil itself.

If everything is assembled correctly, then after turning on the LEDs will start to glow and a small blue spark may appear on the tip of the coil wire (depending on the supply voltage that will be applied to the circuit).

When operating the device, it is not recommended to touch the parts of the circuit.. It is not life threatening, but there is a risk of getting burned.