Description
Peculiarities:
Low power consumption
Fundamental frequency up to 240 MHz, performance up to 600 DMIPS
Memory 520 KB SRAM, 4 MB PSRAM
Supports interfaces, such as UART / SPI / I2C / PWM / ADC / DAC
Supports OV2640 and OV7670 cameras, built-in flash
The ability to transfer images over Wi-Fi
TF card support
Support multiple sleep modes
Built-in Lwip and FreeRTOS
Support STA / AP / STA working mode + AP
Smart Config / AirKiss support
Dmitriy –
The Espressif camera module “falls off” approximately, after a minute
Mikhail Dudnik (verified owner) –
What do you mean by “falling off”?
Alexei –
Why does the stream fall off through 3-10 minutes
Evgeniy (verified owner) –
How to power it from batteries 18650 ?
Andrew Sid –
Satisfied with the purchase, the camera catches artifacts during high quality streaming, but in general all is well.
.Kostya Matveev –
I took a similar module in another store.
1. and falls off, and artifacts.
But! you need to connect in 5v, and from a normal power source. Deshman chargers are not suitable. From the power bank, xiaomi works very stably.
Kolya (verified owner) –
I was sent a defective module that is not flashed, I do not recommend
Syabro –
If you do not know how to connect, use and flash ESP32 modules, then, Fortunately, it's your problem, not the seller. Great product! Corresponds to the declared description. )))
Yuri Buchinsky –
Hello. Who has already ordered this module, tell, what firmware to sew, give a link to the sketch. I can't pick up something. A standard example from arduino is uploaded, camera server goes up, but the image itself is not. Thank you.
Konstantin Lyashenko (verified owner) –
thanks a lot, everything is working.
Was sewn the first time, via USB-TTL / CH340.
Used arduino android